To get into sensor and panel programming on a 2GIG GoControl from the home screen:

1. Tap Security.
2. Tap Menu.
3. Tap Toolbox.
4. Enter the installer code.
5. Scroll to page 3.
6. Tap Installer Toolbox.
7. Tap System Configuration.
8. This section allows you to add and edit wired/RF sensors as well as the entering/editing of individual programming options (called Questions).
   • Scroll left/right to go through different sensors and programming questions.
   • Scroll up/down to go through options for the selected sensor or question.
9. Once all desired changes are made tap End.
10. Verify the settings, then tap to select Save Changes.
11. Tap Exit. The system reboots to save the changes.