You are using an unsupported browser. Please update your browser to the latest version on or before July 31, 2020.
close
You are viewing the article in preview mode. It is not live at the moment.
Home > True Protection > Home Automation Equipment > Trigger buttons for common Z-Wave devices
Trigger buttons for common Z-Wave devices
print icon

Common Z-Wave Device Trigger Actions for Enrollment and Removal

The following table lists the trigger buttons or methods for common Z-Wave devices when enrolling or removing them from a Z-Wave network. These triggers help initiate pairing or exclusion during setup.

For detailed, device-specific instructions, see the Installation and Troubleshooting Guides.

Lights, Switches, and Energy Metering

  • Plug-in Module (All Brands): Tap the button twice while plugged in.
  • In-Wall Switch (All Brands): Click the top or bottom of the rocker twice.
  • In-Wall Outlets: Evolve – tap twice; GE – tap once; Linear – tap once.
  • Smart Energy Meter: Tap the Action/Home Energy Meter button (light stays solid 3 seconds).
  • Smart Energy Switch: Tap the button once while plugged in.
  • Heavy Duty Smart Switch: Tap the action button when powered.
  • GoControl and Qolsys IQ Lightbulbs: Power on; the light blinks to indicate inclusion mode.

Thermostats

  • Alarm.com Thermostat: Press MODE until HEAT and COOL lights are off; hold DOWN until radio icon flashes.
  • Alarm.com Remote Temperature Sensor: Tap the side button once.
  • Trane and RCS Thermostats: Press MENU → Z-WAVE INSTALL → SELECT → YES.
  • 2GIG CT-30 / GE TSTAT-300: Press MENU → MATE twice (the word “link” appears).
  • 2GIG CT-100: Press MENU → MATE twice (the word “Link” appears). Requires 2GIG panel v1.9+.
  • Linear Thermostat: Press FAN until “SETUP” displays → Z-Wave → SELECT.

Locks

  • Kwikset Locks: Press the A (top left) button on the inner side once.
  • Yale Keyed Locks: Enter master code → press # → enter 7,#,1,#.
  • Yale Key-Free Locks: Press the button with the radio icon until it beeps twice.
  • Schlage BE468/469: Press SCHLAGE → enter 6-digit programming code → press 0.
  • Schlage FE599: Enter 6-digit programming code → after 3 lights and 3 beeps, press SCHLAGE → 0.

Other Devices

  • Linear Garage Controller: Tap the side button.
  • The Quickbox: Open with a credential, then press the blue button under the lid.
  • FortrezZ or WaterCop Water Valves: Press the MODE button.

For additional Z-Wave integration or setup help, visit:

Feedback
0 out of 0 found this helpful

Attachments

Trigger_buttons_for_common_Z-Wave_devices.pdf
scroll to top icon