PowerG PIR cameras (PG9934 and PG9944) enrolled on a Qolsys IQ Panel 2 can upload alarm and Peek-in Now images to Alarm.com. 

Captured images are saved in the Images event gallery. For more information about viewing the event gallery, see View the Images Event Gallery and Past Events. 

Requirements

To upload PowerG PIR camera images to the Customer Website and app: 

• The Qolsys IQ Panel 2 must be on firmware version 2.4.0+. 
• The Qolsys IQ Panel 2 must have a PowerG daughtercard attached. 
• The account must have Images - Plus on the service package.
• A PowerG PIR camera (PG9934 and PG9944) must be enrolled on the panel.

Compatibility considerations 

• PowerG PIR cameras are only compatible with capturing alarm and Peek-in Now images. 
  • For alarm images, the PowerG PIR camera captures an image when it detects the first motion after the panel goes into alarm.
  • For more information about requesting Peek-In Now images, see Take an Image Sensor image (Peek-In). 
• PowerG PIR camera uploads for alarms and Peek-in Now images count towards the customer's monthly upload limit. 
• PowerG PIR cameras can be used with Alarm.com Visual Verification for the Qolsys IQ Panel 2. For more information about Alarm.com Visual Verification, see Alarm.com Visual Verification. 

To configure PowerG PIR camera images: 

1. Log into the Customer Website.
2. Click Automation.
3. Click Rules, if not selected already.
4. To enable/disable PowerG PIR camera alarm images, click the toggle switch for the Panel Camera Alarm Image Uploads automation rules. 
   
   Note: Since Peek-ins are manually requested, the Peek-ins rule is always enabled. 
   
   In the following example, the PIR camera is named Motion Detector and is enabled for both rules, along with the panel camera.  
   
    
5. To configure recipient notifications: 

    a. Click  for the automation rule to configure. 

    b. Click + Add.

    c. Select any recipients to be notified from the Address Book dropdown. If the intended recipient is not listed, click + New to add a new recipient address.

    d. Once desired recipients are selected, click Close.

    e. Click Save.