Send a Message to a Qolsys IQ Panel 2
Enterprise Notices allow dealers to send messages to be displayed locally at the panel. There are multiple default messages to choose from that can be sent to the panel. This feature does not allow personalized messages to be sent to the panel. Currently, the messages are only available in English. To send a message…
Dialer delay settings for the Qolsys IQ Panel 2
Dialer delay settings depend on whether SIA limits are enabled. If SIA Limits are enabled: Default 30 seconds Minimum 15 seconds Maximum 45 seconds If SIA Limits are disabled: Default 30 seconds Minimum 0 seconds Maximum 254 seconds Configure SIA Limits To configure SIA Limits using the P…
Remotely Program a Sensor to a Qolsys IQ Panel 2
Sensors can be programmed to a Qolsys IQ Panel 2 remotely using the Partner Portal and MobileTech. Note : Device partitions can be configured on the Qolsys IQ Panel 2 with firmware 2.3.0+. For more information about partitions on the Qolsys IQ Panel 2, see How do multiple partitions work with the Qolsys IQ Panel 2?…
Qolsys IQ Panel 2 Software Version 2.3.0 - Installation Guide
The guides attached to this page have been written by a third party and are not maintained by Alarm.com. Any questions regarding the installation, maintenance, and/or usage instructions in these guides should be directed to the device manufacturer.
Qolsys IQ Panel 2 - Panel-specific app feature compatibility
Some features of the Alarm.com mobile app are available or unavailable depending on panel limitations. For information about which features are available for each app operating system version, see Alarm.com app feature compatibility . App features Panel Silent Arming No Entry Delay Remotely Bypass Sensors Q…
Enable the Qolsys IQ Panel 2 Glass Break Detector
The Qolsys IQ Panel 2 has a built-in glass break detector that is supported by Alarm.com. There is no additional service package add-on required to enable this feature. The panel's glass break detector is enabled using the Qolsys IQ Panel 2, Partner Portal, or MobileTech app. Once enabled, the panel glass break dete…
Adjust the Image Sensor PIR sensitivity on a Qolsys IQ Panel 2
By default, the Image Sensor is configured with a standard motion sensitivity profile Normal . The sensor can also be set to a more sensitive motion profile (i.e., High ) and a less sensitive profile with pet immunity for pets up to 40 lbs (i.e., Low ). Adjust the PIR sensitivity Use the Partner Portal or Mobile…
What is PowerG on the Qolsys IQ Panel 2?
PowerG is a commercial-grade, two-way communications protocol with an extreme range of over 6,000 feet (about 2,000 meters), much greater than the industry standard. The signal automatically adjusts to preserve device battery life, up to eight years. The PowerG network uses Frequency Hopping Spread Spectrum technolo…
Enable the Manage My System Landing Page on a Qolsys IQ Panel 2
The Qolsys IQ Panel 2 supports the Manage My System landing page enabling users to see the panel’s Wi-Fi connectivity status, the panel's software version, and the state of the panel’s Bluetooth radio. The following image is an example of how the Manage My System landing page appears on the Qolsys IQ Panel 2 s…
Enable Qolsys IQ Panel 2 Panel Motion Detector
The Qolsys IQ Panel 2’s panel camera can function as a motion detector. Enabling the panel camera motion detector creates an independent zone that leverages the panel’s built-in camera to act as an activity motion detector. This falls into the zone order at the time you enable this feature. Motion can trip once every…
