You are using an unsupported browser. Please update your browser to the latest version on or before July 31, 2020.
close
You are viewing the article in preview mode. It is not live at the moment.
Home > True Protection > Alarm Systems > 2Gig > GC2/GC2e Panel > 2GIG GoControl - Battery Replacement
2GIG GoControl - Battery Replacement
print icon

The 2GIG GoControl requires a special battery pack available for purchase from the manufacturer. 

Note: The standard backup battery that is included with all 2GIG Control Panels does not support UL 985 installations. To comply with the secondary supply requirement in UL 985: Household Fire Warning System Units, install the 2GIG Console Battery Pack (This is a high‐capacity 2600mAh Ni‐MH replacement battery pack).

To replace the battery in a 2GIG GoControl:

If desired, put the system in test mode with the monitoring station before proceeding.

  1. Disarm the panel.
  2. Power off the panel. 
    1. Unplug the AC adapter.
    2. Unscrew the top to remove the back cover.

      2gig Panel screw
       
    3. Disconnect the battery pack's connector, and remove the old battery.

      clipboard_e00cccabfbe4786b963f04bc01b17c61e.png
       
  3. Plug the new battery pack’s connector into the connector on the Control Panel’s circuit board.
  4. Reinstall the back cover.
  5. Restore AC power.

    Important: The Control Panel does not recognize that the battery is connected until AC power is connected to the power supply.

 

Feedback
0 out of 0 found this helpful

Attachments

clipboard_e00cccabfbe4786b963f04bc01b17c61e.png clipboard_e71c3df45286d739a7f4de283272667ca.png
scroll to top icon