View sensor signal strength for the Qolsys IQ Panel 2
Sensor signal strength for the Qolsys IQ Panel 2 can be viewed using the Partner Portal and MobileTech app. Requirements This feature is only available for newer hardware. The user must have: * Qolsys IQ Panel 2 with firmware version 2.3.0+ * Security RF daughtercard with hardware revision above 0 To verify…
Qolsys IQ Panel 2 - Quick Install Guide
The guides attached to this page have been written by a third party and are not maintained by Alarm.com. Any questions regarding the installation, maintenance, and/or usage instructions in these guides should be directed to the device manufacturer.
Qolsys IQ Panel 2 - Data Sheet
The guides attached to this page have been written by a third party and are not maintained by Alarm.com. Any questions regarding the installation, maintenance, and/or usage instructions in these guides should be directed to the device manufacturer.
Adjust the Notification Volume on the Qolsys IQ Panel 2
The notification volume heard locally on the Qolsys IQ Panel 2 can be adjusted using the Partner Portal, MobileTech app, or the panel itself. To adjust the notification volume using the Partner Portal: * Log into the Partner Portal. * Find the customer account. * Click Remote Toolkit . * In Command Catalog , …
Configure Panel Programming on a Qolsys IQ Panel 2
Panel programming for the Qolsys IQ Panel 2 can be configured locally using the panel or remotely using the Partner Portal or MobileTech app. To configure panel programming using the panel: * Flick down to open the menu, then tap Settings . * Tap Advanced Settings . * Enter the installer code or dealer code. …
Dialer delay settings for the Qolsys IQ Panel 2
Dialer delay settings depend on whether SIA limits are enabled. If SIA Limits are enabled: Default 30 seconds Minimum 15 seconds Maximum 45 seconds If SIA Limits are disabled: Default 30 seconds Minimum 0 seconds Maximum 254 seconds Configure SIA Limits To configure SIA Limits using the P…
Qolsys IQ Panel 2 is Disarming by Itself
If the Qolsys IQ Panel 2 is disarming by itself, verify the following. Verify if Bluetooth disarming is enabled The Qolsys IQ Panel 2 has the ability to enable a Bluetooth device to disarm the system from an armed away state when it comes within range of the panel. When the system is disarmed by the Bluetooth devic…
What device IDs are Image Sensors enrolled in for a Qolsys IQ Panel 2?
Image Sensors can be enrolled in any available device ID on a Qolsys IQ Panel 2. Additional resources Enroll in the Interactive Services & Image Sensor 201 training course today! For more information on accessing Academy Training, see How can I access Academy Training? .
Improve Image Sensor signal strength with a Qolsys IQ Panel 2
The Alarm.com Image Sensor communicates over a radio frequency (RF) to the Image Sensor daughterboard. For proper operation, the Image Sensor requires a minimum of 30% signal strength. Over 40% is recommended. While there are no repeaters to increase Image Sensor RF range, there are a few steps for troubleshooting …
Take a Peek-in from the Qolsys IQ Panel 2 camera
Peek-Ins allow users to take on-demand snapshots from the Qolsys IQ Panel 2 panel camera using the Customer Website and app. Captured Images are saved in the Images event gallery. For more information about viewing the event gallery, see View the Images Event Gallery and Past Events . Compatibility * The Qolsy…
