Configure an auto phone test on a 2GIG GoControl
Auto phone tests (also called timer or periodic tests) help verify that a system is communicating and that the monitoring station is receiving signals. The process can be different from panel to panel, and can be programmed from different ways. If the monitoring station is not receiving auto phone tests, see Monito…
Navigate through system programming on the 2GIG GoControl
To get into sensor and panel programming on a 2GIG GoControl from the home screen: * Tap Security . * Tap Menu . * Tap Toolbox . * Enter the installer code. * Scroll to page 3. * Tap Installer Toolbox . * Tap System Configuration . * This section allows you to add and edit wired/RF sensors as well as th…
2GIG GoControl Panel - User Guide
The guides attached to this page have been written by a third party and are not maintained by Alarm.com. Any questions regarding the installation, maintenance, and/or usage instructions in these guides should be directed to the device manufacturer. To download this guide directly to your device, click 2GIG GoContr…
Find the firmware version of a 2GIG GoControl locally
The firmware version of a 2GIG GoControl can be found in the panel. The firmware version can also be found and requested remotely using the Partner Portal and MobileTech app. For more information about remotely finding the firmware version, see Find or request the firmware version of a panel . To find the firmwar…
2GIG GoControl Panel Version 1.16 - Installation Guide
The guides attached to this page have been written by a third party and are not maintained by Alarm.com. Any questions regarding the installation, maintenance, and/or usage instructions in these guides should be directed to the device manufacturer. To download this guide directly to your device, click 2GIG GoContr…
2GIG GoControl - Monitoring Station Dialer Codes
Monitoring Station dialer codes are led with either a 1 or E to indicate the event signal and led with a 3 or R to indicate a restore signal. The event history on Alarm.com always displays the codes leading with a 1 to indicate the event and 3 to indicate the restore. Reporting Zones 2GIG Type Des…
2GIG GoControl Image Sensor IS-100-GC - Data Sheet
The Image Sensor (model ADC-IS-100-GC) is compatible with the 2GIG GoControl panel with firmware 1.10+. A cell radio and 900 MgHz XCVR2 transceiver are required. The Image Sensor is a breakthrough new product that combines a PIR (Passive Infrared) motion sensor, an integrated still camera, completely wireless commun…
2GIG GoControl - Battery Replacement
The 2GIG GoControl requires a special battery pack available for purchase from the manufacturer. Note : The standard backup battery that is included with all 2GIG Control Panels does not support UL 985 installations. To comply with the secondary supply requirement in UL 985: Household Fire Warning System Units , in…
Adjust the time to detect an AC power failure on a 2GIG GoControl
The amount of time AC power must be lost to trigger an AC power failure for a 2GIG GoControl is controlled by programming Question 38 (Q38). The value entered indicates the number of minutes that AC power must be lost for the status to send to the monitoring station, appear on Alarm.com, and trigger customer notific…
Improve Image Sensor signal strength with a 2GIG GoControl
2GIG Image Sensors do not show the signal strength due to the radio frequency (RF) protocol used by 2GIG. However, 2GIG panels can check if the Image Sensor is connected to the network through the native Sensor Test menu. To access Sensor Test from the panel: * Tap Security . * Tap Menu . * Enter the master o…
