View sensor signal strength for the Qolsys IQ Panel 2
View Sensor Signal Strength on the Qolsys IQ Panel 2 You can view wireless sensor RF health through the Partner Portal or MobileTech. This guide covers the hardware requirements and the steps to retrieve both Latest Sensor Signal Strength and Average Sensor Signal Strength for each device. Requirements * Qols…
Technical Advisory Qolsys IQ Panel 2 - 2.5.2 Software Update
The guides attached to this page have been written by a third party and are not maintained by Alarm.com. Any questions regarding the installation, maintenance, and/or usage instructions in these guides should be directed to the device manufacturer.
Enable the Qolsys IQ Panel 2 Glass Break Detector
Qolsys IQ Panel 2: Enable the Built-In Glass Break Detector The Qolsys IQ Panel 2 includes a built-in glass break detector that’s fully supported by Alarm.com. No extra service add-on is required. Once enabled, it appears in the equipment list under the next available sensor ID as Panel Glass Break . Enable from…
Qolsys IQ Panel 2 - Sensor Groups
Qolsys IQ Panel 2 — Sensor Groups Sensor groups define how each sensor behaves when connected to the Qolsys IQ Panel 2. They determine how the system responds to triggers such as doors opening, motion detection, or glass breakage. What Are Sensor Groups? Each sensor enrolled on the IQ Panel 2 must be assigned to a…
Run Scenes from the Qolsys IQ Panel 2
Program Sensors Remotely on Qolsys IQ Panel 2 Note: Device partitions can be configured on the Qolsys IQ Panel 2 with firmware version 2.3.0+. Program Sensors Using the Partner Portal * Log into the Partner Portal and locate the customer account. * Click Equipment → Sensors . * Configure an existing device:…
Improve Image Sensor signal strength with a Qolsys IQ Panel 2
Alarm.com Image Sensor RF Signal Strength & Troubleshooting About RF Signal Strength The Alarm.com Image Sensor communicates via RF with its daughterboard. For reliable operation: * Minimum: 30% signal strength * Recommended: 40%+ signal strength Applies to: Image Sensor version 2 & 2.2 models (ADC-IS-200, AD…
Enable the Manage My System Landing Page on a Qolsys IQ Panel 2
Qolsys IQ Panel 2 – “Manage My System” Landing Page What You’ll See * Wi-Fi connectivity status (connected/disconnected, useful before dual-path testing) * Panel software version (verify before scheduling firmware updates) * Bluetooth radio state (On/Off; helpful when using Bluetooth Disarming) Note: There a…
Enroll an Image Sensor on a Qolsys IQ Panel 2
Qolsys IQ Panel 2 – Enroll Image Sensors Requirements * Image Sensor daughter card is installed on the IQ Panel 2. * Customer account includes the Images add-on. * A communication test has completed successfully ( how to send ). Helpful: Ensure the panel is connected to Wi-Fi for smoother provisioning ( Wi…
Interact with Garage Doors from a Qolsys IQ Panel 2
Qolsys IQ Panel 2 – Control Z-Wave & LiftMaster Garage Doors Overview The Qolsys IQ Panel 2 lets you view status and open/close compatible Z-Wave Linear and LiftMaster garage door devices directly from the panel. Firmware requirement: For LiftMaster compatibility, the panel must be on firmware 2.4.0+ . Aft…
Qolsys IQ Panel 2 Software Version 2.3.0 - Installation Guide
Third-Party Guides Disclaimer The guides attached to this page have been written by a third party and are not maintained by True Protection . Important: Any questions regarding installation, maintenance, or usage instructions in these guides should be directed to the device manufacturer . Need True Protection…
