2GIG GoControl - Two-Way Voice Installation Guide
The 2GIG GoControl supports Two-Way Voice. This gives the 2GIG GoControl Panel’s cellular radio module the ability to automatically dial the monitoring station and connect with an operator after an alarm sounds. Once connected with the monitoring station, people on the premises can communicate with the operator using…
2GIG GoControl Image Sensor ADC-IS-200-GC - Installation Guide
2GIG part number: 2GIG-IMAGE1 Alarm.com part number: ADC-IS-200-GC Alarm.com Image Sensor for 2GIG GoControl Product summary The Image Sensor is a pet immune PIR (passive infrared) motion detector with a built-in camera. The sensor is designed to capture images during alarm or non-alarm events. Users can also ini…
Unable to perform a Cell Phone Test on a 2GIG GoControl
If the 2GIG GoControl is unable to perform a test or the Cell Phone Test option does not appear, try the following troubleshooting steps. Verify panel is compatible with the module There are panel firmware requirements for the 3G and 4G networks. For more information about the networks, see What are the firmware…
2GIG GoControl - Equipment Codes
Equipment Code Equipment Description Panel firmware version required 9999 Alarm.com Image Sensor Note : Must be added at the panel 1.10+ 1062 2GIG Tilt Sensor 1.19+ 1064 2GIG Bypass Sensor 1.14+ 1065 2GIG Flood Sensor 1.14+ 1066 2GIG Shock Sensor 1…
Disable trouble beeps on a 2GIG GoControl
There is no way to indefinitely disable trouble beeps at all times for the 2GIG GoControl panel. Trouble beeps include beeps caused by AC power loss, system low battery, sensor low battery or RF supervision, failure to communicate with the Monitoring Station, control panel tampering while disarmed, and cell radio fau…
2GIG GoControl Image Sensor ADC-IS-100-GC - Installation Guide
2GIG part number: 2GIG-IMAGE1 Alarm.com part number: ADC-IS-100-GC Product summary The Image Sensor is a pet immune PIR (passive infrared) motion detector with a built-in camera. The sensor is designed to capture images during alarm or non-alarm events. Users can also initiate image capture on-demand to Peek-In …
2GIG GoControl - Cellular Module Installation Guide
It is strongly suggested to perform the steps shown in this guide in your office or lab at least 24 hours before going to the installation site. This ensures that the SIM card will be ready to communicate with Alarm.com and also allow you to detect any possible problems before going to the client site. The advantage…
Change the language of a 2GIG GoControl
The language of a 2GIG GoControl is part of its firmware. An Over-The-Air (OTA) upgrade to a different language version can be sent using the Partner Portal or MobileTech app. Language firmware can also be applied locally at the panel using 2GIG's upgrade cable and a computer. For more information about local upgrad…
