PIR sensitivity settings By default, the Image Sensor is configured with a standard motion sensitivity profile Normal . The sensor can also be set to a more sensitive motion profile (i.e., High ) and a less sensitive profile with pet immunity for pets up to 40 lbs (i.e., Low ). The sensitivity can be configured t…
Sending a communication test from the panel initiates communication and verifies that the module is communicating on the cellular network. For this test to send a signal to the monitoring station, verify Manual/Auto Tests are selected as an Event to Forward in the customer's Monitoring Settings . For more info…
Auto phone tests (also called Timer or Periodic Tests) help verify that a system is communicating and that the monitoring station is receiving signals. The process can be different from panel to panel, and can be programmed in different ways. If the monitoring station is not receiving auto phone tests, see Monitori…
The serial number for sensors enrolled on a 2GIG GC3 can be found remotely using the Partner Portal or MobileTech app. For information about finding the serial number for a deleted sensor, see Remotely find the serial number for a deleted sensor . To find the serial number of a sensor using the Partner Portal: *…
The Alarm.com Image Sensor communicates over a radio frequency (RF) to the GC3 panel. For proper operation, the Image Sensor requires a minimum of 30% signal strength. Over 40% is recommended. While there are no repeaters to increase Image Sensor RF range, there are a few steps for troubleshooting signal strength a…
The firmware version of a 2GIG GC3 can be found locally using the panel. The firmware version can also be found and requested remotely using the Partner Portal and MobileTech app. For more information about remotely finding the firmware version, see Find or request the firmware version of a panel . To find the fi…
The guides attached to this page have been written by a third party and are not maintained by Alarm.com. Any questions regarding the installation, maintenance, and/or usage instructions in these guides should be directed to the device manufacturer. To download this guide directly to your device, click 2GIG GC3 Pan…
Enterprise Notices allow dealers to send messages to be displayed locally at the panel. There are multiple default messages to choose from that can be sent to the panel. This feature does not allow personalized messages to be sent to the panel. Currently, the messages are only available in English. To send messages…
he 2GIG GC3 panel allows users to interact with Z-Wave lights, locks, thermostats, and garage devices locally at the panel. For information on adding Z-Wave devices, see Manage Z-Wave devices on a 2GIG GC3 . Note : Additional Z-Wave devices may be able to be added and controlled locally. For more information, refer…
Dialer delay settings * Default dialer delay is 30 seconds. * Minimum is 15 seconds. * Maximum is 45 seconds. Panic alarm forwarding Note : These are panel programming specific and cannot be changed. On the 2GIG GC3, the following alarms send immediately with no dialer delay: * Duress code * Silent panic *…