Enroll an Image Sensor on a 2GIG GoControl
Requirements The following are required to enroll Image Sensors to a 2GIG GoControl panel: * A customer account has been created on Alarm.com with a service package that includes an Images add-on. * The Alarm.com module and XCVR2 transceiver are installed properly in the panel. * A cell phone test has been per…
2GIG GC3 - Two-Way Voice Installation Guide
The 2GIG GC3 supports Two-Way Voice. This gives the 2GIG GC3 Panel’s cellular radio module the ability to automatically dial the monitoring station and connect with an operator after an alarm sounds. Once connected with the monitoring station, people on the premises can communicate with the operator using the 2GIG GC…
Configure the Go!Bridge with a 2GIG GoControl panel
End of Life for 2GIG Go!Bridge Nortek has announced the discontinuation of the 2GIG Go!Bridge as of April 8, 2020. Any Go!Bridges that have already been distributed will continue to be supported, including those that have not been attached to accounts yet. For more information about the announcement, see Nortek's G…
2GIG GoControl - Signaling Troubleshooting Guide
Note : To ensure a stable connection, the panel should read a signal strength of at least 15/31 and successfully complete a communication test. Prior to installation: * Verify the panel is on a compatible firmware version to support the LTE module. For more information about compatibility, see What are the firmwa…
Enable Weather to Panel on a 2GIG GoControl
Alarm.com offers weather to be displayed on compatible panels. The 2GIG GoControl is compatible with Weather to Panel . On the 2GIG GoControl, the current day's forecast displays until 6:00 PM locally. After 6:00 PM, the panel displays Tomorrow's Forecast . The panel resumes displaying Today's Forecast at 12:00 …
2GIG GoControl Image Sensor ADC-IS-220-GC - Installation Guide
Product summary The Image Sensor is a pet immune PIR (passive infrared) motion detector with a built-in camera. The sensor is designed to capture images during alarm or non-alarm events. Users can also initiate image capture on-demand to Peek-In on their property. Images are stored locally and uploaded either automa…
2GIG GC3 Image Sensor (2GIG-IMAGE2) - Installation Guide
Product overview The Image Sensor for 2GIG GC3 panels is a pet immune PIR (passive infrared) motion detector with a built-in camera. The sensor is designed to capture images during alarm or non-alarm events. Users can also initiate image capture on-demand to Peek-In on their property. Images are stored locally and …
Enroll an Image Sensor on a 2GIG GC3
Requirements The following are required to enroll Image Sensors to a 2GIG GC3 panel: * A customer account has been created on Alarm.com with a service package that includes an Images add-on. * The Alarm.com module and XCVR3 transceiver are installed properly in the panel. For more information about installing t…
Failed install during 2GIG GoControl Image Sensor installation
If there is a Failed Install message or Image Sensors are failing to enroll, remove the Image Sensor and then re-enroll the device. To remove an Image Sensor: Change the sensor type of the Image Sensor to Unused to remove the device. This removes any device information from the Image Sensor that may be in the p…
2GIG Super Switch Takeover Module (2GIG-TAKE-345) - Installation Guide
The guides attached to this page have been written by a third party and are not maintained by Alarm.com. Any questions regarding the installation, maintenance, and/or usage instructions in these guides should be directed to the device manufacturer. To download this guide directly to your device, click 2GIG Super…
