Interact with a Z-Wave device from a 2GIG GC3
he 2GIG GC3 panel allows users to interact with Z-Wave lights, locks, thermostats, and garage devices locally at the panel. Note : Additional Z-Wave devices may be able to be added and controlled locally. For more information, refer to the device manufacturer. To interact with Z-Wave lights from a 2GIG GC3: * Tap…
2GIG GC3 - Battery Replacement
The content on this page has been written by a third party and is not maintained by Alarm.com. Any questions regarding the installation, maintenance, and/or usage instructions in this guide should be directed to the device manufacturer. To access the full installation guide, see 2GIG GC3 Panel - Installation Gui…
2GIG GoControl Panic Button Remote - Installation Guide
The guides attached to this page have been written by a third party and are not maintained by Alarm.com. Any questions regarding the installation, maintenance, and/or usage instructions in these guides should be directed to the device manufacturer. To download this guide directly to your device, click 2GIG GoContr…
2GIG Z-Wave Thermostat (CT-100) - Battery Replacement
2GIG CT-100 Thermostat Battery Replacement & End of Support Notice Important Notice: Alarm.com ended support for the 2GIG CT-100, 2GIG CT-30, and GE TSTAT-300 thermostats on May 27, 2018. These models cannot be controlled from the app or website on new or recycled accounts created after that date. Accounts create…
Add user codes to a 2GIG GC3 panel
User codes can be added to the 2GIG GC3 panel locally or remotely using Alarm.com. For information about adding user codes remotely, see Add user codes remotely . To add user codes locally using the 2GIG GC3 panel: * Tap System Settings . * Enter the installer code or master code. * Tap Users . * Tap Add Us…
Cell module not detected displays on a 2GIG GC3
If Cell module not detected displays on a 2GIG GC3, perform the following steps to locally resolve the behavior. How to resolve: Verify compatible panel firmware Verify the panel firmware version is compatible with the module. Select Cell Radio Swap If the panel firmware version is compatible, select Cell Radi…
Clear a severe weather alert from a 2GIG GoControl
Severe weather alerts to the panel notify customers of incoming dangerous weather. The alerts only come in for tornado, fire, or tsunami warnings. When an alert comes in, there will be a series of audible beeps and a message on the panel. For more information on severe weather alerts, see Severe Weather Alerts . N…
2GIG GC3 - Sensor Groups
Each sensor (wireless or wired) installed in the system is programmed to a specific sensor number and sensor type (zone). The sensor number identifies the specific sensor when it is displayed on the Control Panel, recorded in the event log, or reported to the monitoring station. This allows pinpointing information…
2GIG GoControl - Battery Replacement
HowTo SchemaSupport › Control Panels › Power & Batteries 2GIG GoControl Panel Battery Replacement Guide About the Required Battery Pack The 2GIG GoControl panel uses a special console battery pack available from the manufacturer. The standard backup battery included with 2GIG control panels does not support UL 98…
Adjust the Image Sensor PIR sensitivity on a 2GIG GoControl
PIR sensitivity settings By default, the Image Sensor is configured with a standard motion sensitivity profile Normal . The sensor can also be set to a more sensitive motion profile (i.e., High ) and a less sensitive profile with pet immunity for pets up to 40 lbs (i.e., Low ). The sensitivity can be configured …
