2GIG GC3 Image Sensor Transceiver (2GIG-XCVR3-GC3) - Installation Guide
The guides attached to this page have been written by a third party and are not maintained by Alarm.com. Any questions regarding the installation, maintenance, and/or usage instructions in these guides should be directed to the device manufacturer. To download this guide directly to your device, click 2GIG GC3 Ima…
Find the firmware version of a 2GIG GoControl locally
The firmware version of a 2GIG GoControl can be found in the panel. The firmware version can also be found and requested remotely using the Partner Portal and MobileTech app. For more information about remotely finding the firmware version, see Find or request the firmware version of a panel . To find the firmwar…
What are the dialer delay settings for the 2GIG GC3?
Dialer delay settings * Default dialer delay is 30 seconds. * Minimum is 15 seconds. * Maximum is 45 seconds. Panic alarm forwarding Note : These are panel programming specific and cannot be changed. On the 2GIG GC3, the following alarms send immediately with no dialer delay: * Duress code * Silent panic *…
Improve Image Sensor signal strength with a 2GIG GoControl
2GIG Image Sensors do not show the signal strength due to the radio frequency (RF) protocol used by 2GIG. However, 2GIG panels can check if the Image Sensor is connected to the network through the native Sensor Test menu. To access Sensor Test from the panel: * Tap Security . * Tap Menu . * Enter the master o…
Enable or disable quick arming on a 2GIG GoControl
Quick arming allows the user to arm the system without having to enter their user code. Quick arming can be adjusted using the Partner Portal, MobileTech app, or the 2GIG panel. To enable or disable quick arming using the Partner Portal: * Log into the Partner Portal. * Find the customer account. * Click Remote…
Connect a 2GIG GC3 to a Wi-Fi network
The panel can be connected to a Wi-Fi network by either manually selecting the network or using Wireless Protected Setup (WPS). Once the system is connected to Wi-Fi, Dual-Path communication can also be enabled. For more information about enabling Dual-Path, see Enable or disable Dual-Path communication remotely . …
2GIG GC3 - Sensor Groups
Each sensor (wireless or wired) installed in the system is programmed to a specific sensor number and sensor type (zone). The sensor number identifies the specific sensor when it is displayed on the Control Panel, recorded in the event log, or reported to the monitoring station. This allows pinpointing information…
2GIG GoControl Image Sensor IS-100-GC - Data Sheet
The Image Sensor (model ADC-IS-100-GC) is compatible with the 2GIG GoControl panel with firmware 1.10+. A cell radio and 900 MgHz XCVR2 transceiver are required. The Image Sensor is a breakthrough new product that combines a PIR (Passive Infrared) motion sensor, an integrated still camera, completely wireless commun…
Improve Image Sensor signal strength with a 2GIG GC3
The Alarm.com Image Sensor communicates over a radio frequency (RF) to the GC3 panel. For proper operation, the Image Sensor requires a minimum of 30% signal strength. Over 40% is recommended. While there are no repeaters to increase Image Sensor RF range, there are a few steps for troubleshooting signal strength a…
2GIG GC3 - Battery Replacement
The content on this page has been written by a third party and is not maintained by Alarm.com. Any questions regarding the installation, maintenance, and/or usage instructions in this guide should be directed to the device manufacturer. To access the full installation guide, see 2GIG GC3 Panel - Installation Gui…
