Enterprise Notices allow dealers to send messages to be displayed locally at the panel. There are multiple default messages to choose from that can be sent to the panel. This feature does not allow personalized messages to be sent to the panel. Currently, the messages are only available in English. To send messages…
To get into sensor and panel programming on a 2GIG GoControl from the home screen: * Tap Security . * Tap Menu . * Tap Toolbox . * Enter the installer code. * Scroll to page 3. * Tap Installer Toolbox . * Tap System Configuration . * This section allows you to add and edit wired/RF sensors as well as th…
he 2GIG GC3 panel allows users to interact with Z-Wave lights, locks, thermostats, and garage devices locally at the panel. For information on adding Z-Wave devices, see Manage Z-Wave devices on a 2GIG GC3 . Note : Additional Z-Wave devices may be able to be added and controlled locally. For more information, refer…
The guides attached to this page have been written by a third party and are not maintained by Alarm.com. Any questions regarding the installation, maintenance, and/or usage instructions in these guides should be directed to the device manufacturer. To download this guide directly to your device, click 2GIG GC3 Pan…
Dialer delay settings * Default dialer delay is 30 seconds. * Minimum is 15 seconds. * Maximum is 45 seconds. Panic alarm forwarding Note : These are panel programming specific and cannot be changed. On the 2GIG GC3, the following alarms send immediately with no dialer delay: * Duress code * Silent panic *…
The guides attached to this page have been written by a third party and are not maintained by Alarm.com. Any questions regarding the installation, maintenance, and/or usage instructions in these guides should be directed to the device manufacturer. To download this guide directly to your device, click 2GIG GoContr…
Panel programming for the 2GIG GC3 can be configured locally using the panel or remotely using the Partner Portal or MobileTech app. To configure panel programming using the panel: * On the home screen, tap System Settings . * Enter the installer code. * Tap Installer Toolbox . * Tap System Configuration . …
If the error message Remote provider not set displays when trying to send a communication test, verify Q7 is set to Alarm.com in panel programming on the 2GIG GC3. To verify Q7 using the 2GIG GC3: * Tap System Settings . * Enter the installer code. * Tap Installer Toolbox . * Tap System Configuration .…
The guides attached to this page have been written by a third party and are not maintained by Alarm.com. Any questions regarding the installation, maintenance, and/or usage instructions in these guides should be directed to the device manufacturer. To download this guide directly to your device, click 2GIG GoContr…
The firmware version of a 2GIG GoControl can be found in the panel. The firmware version can also be found and requested remotely using the Partner Portal and MobileTech app. For more information about remotely finding the firmware version, see Find or request the firmware version of a panel . To find the firmwar…